91°µÍø

The technology described reduces the porosity from the printed parts in the material feeding line and improve mechanical properties.

Concrete floor slab flatness and levelness are parameters often specified in construction documents that contractors must meet to ensure a high quality of construction. However, the measurement of these parameters is cumbersome and time-consuming.

Complex protective casings and housings are necessary for many applications, including combustion chambers of gas turbines used in aerospace engines. Manufacturing these components from forging and/or casting as a whole is challenging, costly, and time-consuming.

Anisotropic bonded critical rare earth free permanent magnets in a polymer matrix fabricated using an additive manufacturing process.

Compliance in a part, work holding, or base plate is beneficial for certain processes, but detrimental for machining and material removal.

This technology creates a light and metalless current collector for battery application. Cathodes coated on this new current collector demonstrated similar contact resistance, lower charge transfer resistance and similar or high rate performance.

In additive manufacturing large stresses are induced in the build plate and part interface. A result of theses stresses are deformations in the build plate and final component.

Additively manufacturing of the windings with a conductor distributed in the cross-section according to the Hilbert curve provides many benefits as it allows for the reduction of the high-frequency losses due to the reduction of the effective winding conductor size.

In wire-arc additive manufacturing and hot-wire laser additive manufacturing, wire is fed into a melt pool and melted through the arc or laser process.