81 - 90 of 107 Results
Compliance in a part, work holding, or base plate is beneficial for certain processes, but detrimental for machining and material removal.
In additive manufacturing large stresses are induced in the build plate and part interface. A result of theses stresses are deformations in the build plate and final component.
In wire-arc additive manufacturing and hot-wire laser additive manufacturing, wire is fed into a melt pool and melted through the arc or laser process.
Liners in Type-IV hydrogen storage tanks often fail due to hydrogen saturation, additional weight and design limitations due to expensive tooling for conventional molding technique.
In manufacturing parts for industry using traditional molds and dies, about 70 percent to 80 percent of the time it takes to create a part is a result of a relatively slow cooling process.
Important of the application is enabling a cost-effective precision manufacturing method Current technology is limited to injection molded individual pi-joints limiting control of pi-joint direction, this creates hurdle in introducing high volume production to the composite in
This technology aims to provide and integrated and oxidation resistant cladding or coating onto carbon-based composites in seconds.