41 - 50 of 54 Results
In additive manufacturing large stresses are induced in the build plate and part interface. A result of theses stresses are deformations in the build plate and final component.
In wire-arc additive manufacturing and hot-wire laser additive manufacturing, wire is fed into a melt pool and melted through the arc or laser process.
In manufacturing parts for industry using traditional molds and dies, about 70 percent to 80 percent of the time it takes to create a part is a result of a relatively slow cooling process.
This technology aims to provide and integrated and oxidation resistant cladding or coating onto carbon-based composites in seconds.
Efficient CO2 capture using deep eutectic solvents with modular, scalable membrane contactors.
Simurgh revolutionizes industrial CT imaging with AI, enhancing speed and accuracy in nondestructive testing for complex parts, reducing costs.
Adhesive and sealant materials are crucial in construction, automotive, and electronics industries. However, most adhesives fail under stress or environmental conditions like dust, water, or wear.